problem 7119
Moderátoři: lacoland, helix26, By.Bob
problem 7119
hello all my problem is 7119 blocked on 7119 and flashes red impossible from put the original.
Re: problem 7119
hello all person for help my thanks.
Re: problem 7119
hello all this my problem look the loog:
usb upgrage
USB: scanning bus for devices... 2 USB Device(s) found
scanning bus for storage devices... 1 Storage Device(s) found
Interface: USB
Device 0: Vendor: SanDisk Prod.: Cruzer Blade Rev: 1.26
Type: Removable Hard Disk
Capacity: 3819.0 MiB = 3.7 GiB (7821312 x 512)
Partition 1: Filesystem: FAT32 "NO NAME "
reading usb_uboot.img
reading usb_config.img
usb_config.img not found
reading usb_kernel.img
usb_kernel.img not found
reading usb_rootfs.img
usb_rootfs.img not found
reading usb_uboot.img
.....................
Skipping bad block at 0x00000000
Skipping bad block at 0x00020000
Bad block at 0x0 in erase block from 0x0 will be skipped
Bad block at 0x20000 in erase block from 0x20000 will be skipped
Bad block at 0x60000 in erase block from 0x60000 will be skipped
Bad block at 0x80000 in erase block from 0x80000 will be skipped
Bad block at 0xa0000 in erase block from 0xa0000 will be skipped
Bad block at 0xc0000 in erase block from 0xc0000 will be skipped
Bad block at 0xe0000 in erase block from 0xe0000 will be skipped
Writing data at 0x116800 -- 100% complete.
Hit any key to stop autoboot: 0
(Re)start USB...
USB: scanning bus for devices... 2 USB Device(s) found
scanning bus for storage devices... 1 Storage Device(s) found
reading uImage
** Unable to read "uImage" from usb 0:1 **
## Booting image at 80000000 ...
Image Name: 7119
Image Type: SuperH Linux Firmware (gzip compressed)
Data Size: 224775 Bytes = 219.5 KiB
Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
Wrong Image Type for bootm command
NAND read: device 0 offset 0x60000, size 0x300000
Bad block at 0x60000 in erase block from 0x60000 will be skipped
Bad block at 0x80000 in erase block from 0x80000 will be skipped
Bad block at 0xa0000 in erase block from 0xa0000 will be skipped
Bad block at 0xc0000 in erase block from 0xc0000 will be skipped
Bad block at 0xe0000 in erase block from 0xe0000 will be skipped
reading NAND page at offset 0x100000 failed
3145728 bytes read: ERROR
## Booting image at 80000000 ...
Image Name: 7119
Image Type: SuperH Linux Firmware (gzip compressed)
Data Size: 224775 Bytes = 219.5 KiB
Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
Wrong Image Type for bootm command
7119 >
usb upgrage
USB: scanning bus for devices... 2 USB Device(s) found
scanning bus for storage devices... 1 Storage Device(s) found
Interface: USB
Device 0: Vendor: SanDisk Prod.: Cruzer Blade Rev: 1.26
Type: Removable Hard Disk
Capacity: 3819.0 MiB = 3.7 GiB (7821312 x 512)
Partition 1: Filesystem: FAT32 "NO NAME "
reading usb_uboot.img
reading usb_config.img
usb_config.img not found
reading usb_kernel.img
usb_kernel.img not found
reading usb_rootfs.img
usb_rootfs.img not found
reading usb_uboot.img
.....................
Skipping bad block at 0x00000000
Skipping bad block at 0x00020000
Bad block at 0x0 in erase block from 0x0 will be skipped
Bad block at 0x20000 in erase block from 0x20000 will be skipped
Bad block at 0x60000 in erase block from 0x60000 will be skipped
Bad block at 0x80000 in erase block from 0x80000 will be skipped
Bad block at 0xa0000 in erase block from 0xa0000 will be skipped
Bad block at 0xc0000 in erase block from 0xc0000 will be skipped
Bad block at 0xe0000 in erase block from 0xe0000 will be skipped
Writing data at 0x116800 -- 100% complete.
Hit any key to stop autoboot: 0
(Re)start USB...
USB: scanning bus for devices... 2 USB Device(s) found
scanning bus for storage devices... 1 Storage Device(s) found
reading uImage
** Unable to read "uImage" from usb 0:1 **
## Booting image at 80000000 ...
Image Name: 7119
Image Type: SuperH Linux Firmware (gzip compressed)
Data Size: 224775 Bytes = 219.5 KiB
Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
Wrong Image Type for bootm command
NAND read: device 0 offset 0x60000, size 0x300000
Bad block at 0x60000 in erase block from 0x60000 will be skipped
Bad block at 0x80000 in erase block from 0x80000 will be skipped
Bad block at 0xa0000 in erase block from 0xa0000 will be skipped
Bad block at 0xc0000 in erase block from 0xc0000 will be skipped
Bad block at 0xe0000 in erase block from 0xe0000 will be skipped
reading NAND page at offset 0x100000 failed
3145728 bytes read: ERROR
## Booting image at 80000000 ...
Image Name: 7119
Image Type: SuperH Linux Firmware (gzip compressed)
Data Size: 224775 Bytes = 219.5 KiB
Load Address: 00000000
Entry Point: 00000000
Verifying Checksum ... OK
Wrong Image Type for bootm command
7119 >