Update Capitol pro HDBOXY

[revis]

error code table http://www.ab-forum.info/download/file. ... &mode=view

[revis]

er01 - Receiver ID does not fit, you need to change over resselerID changer type of receiver to match the ID that is already in the box.

[samkooke]

yes i have changed resselerId

[revis]

Yes, right. But it did not change the type which you have actually now in the box to the original software, or can not remember

[samkooke]

is not starkit 7919 this is starkit hdbox 9105+ 7200 kleio

[revis]

I check , please wait

[revis]

Sorry, already corrected

[samkooke]

thanks revis.

[samkooke]

is no work it will not start it is blocked on 7919.

[revis]

Download again - this should be corrected.
we Nerine box, you have to test you.
Attach the console log, if it will not work.
Thanks

[samkooke]

no always the same issue not start it is blocked on 7919 ???

[revis]

No, there is not yet any blocking. Nerine box I do not have tested the man who goes seemingly everything .... even when it is not.

Bite enclose serial log from the start of receiver .

[samkooke]

Hello,

You can find following the Log of 7919 :



DRAM: 256 MiB
NAND: 256 MiB
*** Warning - bad CRC or NAND, using default environment

In: serial
Out: serial
Err: serial
set ethaddr 00:1e:b8:0a:3a:fa
done
Setup mac address.
read_key 0
done
Hit any key to stop autoboot: 0
(Re)start USB...
USB: scanning bus for devices... 2 USB Device(s) found
scanning bus for storage devices... 0 Storage Device(s) found
** Can't read from device 0 **

** Unable to use usb 0:1 for fatload **
## Booting image at 80000000 ...
Bad Magic Number

NAND read: device 0 offset 0x60000, size 0x300000

Reading data from 0x35f800 -- 100% complete.
3145728 bytes read: OK
## Booting image at 80000000 ...
Image Name: Linux-2.6.32.61_stm24_0216
Image Type: SuperH Linux Kernel Image (gzip compressed)
Data Size: 2342762 Bytes = 2.2 MiB
Load Address: 80801000
Entry Point: 80802000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK

Starting kernel console=ttyAS0,115200 panic=1 ubi.mtd=3 root=ubi0:rootfs rootfstype=ubifs rw coprocessor_mem=4m@0x40000000,4m@0x40400000 - 0x00000000 - 0 ...



U-Boot 1.3.1 (Nov 15 2013 - 23:53:18) - stm23_0046

DRAM: 256 MiB
NAND: 256 MiB
*** Warning - bad CRC or NAND, using default environment

In: serial
Out: serial
Err: serial
set ethaddr 00:1e:b8:0a:3a:fa
done
Setup mac address.
read_key 0
done
Hit any key to stop autoboot: 0
(Re)start USB...
USB: scanning bus for devices... 2 USB Device(s) found
scanning bus for storage devices... 0 Storage Device(s) found
** Can't read from device 0 **

** Unable to use usb 0:1 for fatload **
## Booting image at 80000000 ...
Image Name: Linux-2.6.32.61_stm24_0216
Image Type: SuperH Linux Kernel Image (gzip compressed)
Data Size: 2342762 Bytes = 2.2 MiB
Load Address: 80801000
Entry Point: 80802000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK

Starting kernel console=ttyAS0,115200 panic=1 ubi.mtd=3 root=ubi0:rootfs rootfstype=ubifs rw coprocessor_mem=4m@0x40000000,4m@0x40400000 - 0x00000000 - 0 ...



U-Boot 1.3.1 (Nov 15 2013 - 23:53:18) - stm23_0046

DRAM: 256 MiB
NAND: 256 MiB
*** Warning - bad CRC or NAND, using default environment

In: serial
Out: serial
Err: serial
set ethaddr 00:1e:b8:0a:3a:fa
done
Setup mac address.
read_key 0
done
Hit any key to stop autoboot: 0
(Re)start USB...
USB: scanning bus for devices... 2 USB Device(s) found
scanning bus for storage devices... 0 Storage Device(s) found
** Can't read from device 0 **

** Unable to use usb 0:1 for fatload **
## Booting image at 80000000 ...
Image Name: Linux-2.6.32.61_stm24_0216
Image Type: SuperH Linux Kernel Image (gzip compressed)
Data Size: 2342762 Bytes = 2.2 MiB
Load Address: 80801000
Entry Point: 80802000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK

Starting kernel console=ttyAS0,115200 panic=1 ubi.mtd=3 root=ubi0:rootfs rootfstype=ubifs rw coprocessor_mem=4m@0x40000000,4m@0x40400000 - 0x00000000 - 0 ...



U-Boot 1.3.1 (Nov 15 2013 - 23:53:18) - stm23_0046

DRAM: 256 MiB
NAND: 256 MiB
*** Warning - bad CRC or NAND, using default environment

In: serial
Out: serial
Err: serial
set ethaddr 00:1e:b8:0a:3a:fa
done
Setup mac address.
read_key 0
done
Hit any key to stop autoboot: 0
(Re)start USB...
USB: scanning bus for devices... 2 USB Device(s) found
scanning bus for storage devices... 0 Storage Device(s) found
** Can't read from device 0 **

** Unable to use usb 0:1 for fatload **
## Booting image at 80000000 ...
Image Name: Linux-2.6.32.61_stm24_0216
Image Type: SuperH Linux Kernel Image (gzip compressed)
Data Size: 2342762 Bytes = 2.2 MiB
Load Address: 80801000
Entry Point: 80802000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK

Starting kernel console=ttyAS0,115200 panic=1 ubi.mtd=3 root=ubi0:rootfs rootfstype=ubifs rw coprocessor_mem=4m@0x40000000,4m@0x40400000 - 0x00000000 - 0 ...



U-Boot 1.3.1 (Nov 15 2013 - 23:53:18) - stm23_0046

DRAM: 256 MiB
NAND: 256 MiB
*** Warning - bad CRC or NAND, using default environment

In: serial
Out: serial
Err: serial
set ethaddr 00:1e:b8:0a:3a:fa
done
Setup mac address.
read_key 0
done
Hit any key to stop autoboot: 0
(Re)start USB...
USB: scanning bus for devices... 2 USB Device(s) found
scanning bus for storage devices... 0 Storage Device(s) found
** Can't read from device 0 **

** Unable to use usb 0:1 for fatload **
## Booting image at 80000000 ...
Image Name: Linux-2.6.32.61_stm24_0216
Image Type: SuperH Linux Kernel Image (gzip compressed)
Data Size: 2342762 Bytes = 2.2 MiB
Load Address: 80801000
Entry Point: 80802000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK

Starting kernel console=ttyAS0,115200 panic=1 ubi.mtd=3 root=ubi0:rootfs rootfstype=ubifs rw coprocessor_mem=4m@0x40000000,4m@0x40400000 - 0x00000000 - 0 ...



U-Boot 1.3.1 (Nov 15 2013 - 23:53:18) - stm23_0046

DRAM: 256 MiB
NAND: 256 MiB
*** Warning - bad CRC or NAND, using default environment

In: serial
Out: serial
Err: serial
set ethaddr 00:1e:b8:0a:3a:fa
done
Setup mac address.
read_key 0
done
Hit any key to stop autoboot: 0
(Re)start USB...
USB: scanning bus for devices... 2 USB Device(s) found
scanning bus for storage devices... 0 Storage Device(s) found
** Can't read from device 0 **

** Unable to use usb 0:1 for fatload **
## Booting image at 80000000 ...
Image Name: Linux-2.6.32.61_stm24_0216
Image Type: SuperH Linux Kernel Image (gzip compressed)
Data Size: 2342762 Bytes = 2.2 MiB
Load Address: 80801000
Entry Point: 80802000
Verifying Checksum ... OK
Uncompressing Kernel Image ... OK

Starting kernel console=ttyAS0,115200 panic=1 ubi.mtd=3 root=ubi0:rootfs rootfstype=ubifs rw coprocessor_mem=4m@0x40000000,4m@0x40400000 - 0x00000000 - 0 ...



U-Boot 1.3.1 (Nov 15 2013 - 23:53:18) - stm23_0046

DRAM: 256 MiB
NAND: 256 MiB
*** Warning - bad CRC or NAND, using default environment

In: serial
Out: serial
Err: serial
set ethaddr 00:1e:b8:0a:3a:fa
done

[revis]

thanks

[samkooke]

hello what new.

[revis]

U-Boot 1.3.1 (Nov 15 2013 - 23:53:18) - stm23_0046

old u-boot ! pleas install new uboot ! Capitol only for new uboot , no support old !

[sida]

Your bootloader is old U-Boot 1.3.1 (Nov 15 2013 - 23:53:18) - stm23_0046

[samkooke]

ok or is the new uboot thanks.

[sida]

ok or is the new uboot thanks.

No new u-boot is : U-Boot 1.3.1 (Jan 30 2015 - 22:56:36) - stm23_0046

[samkooke]

thanks sida revis is work i have changed the bootloader L 7.37 thanks.